SERVICING
Before contacting your local Tricity BendixThe machine does not dry
Service Centre, please make the followingnThe drying time has not been selected
checks:
nThe water taps are not turned on
nThe drain filter is clogged
The machine does not start up
nThe machine is overloaded
nThe ON/OFF button has not been depressed
nThe selected drying time is not adequate
nThe door is not closed properly
nNo water is entering the machine (see: the machine
If, after the above checks, there is still a fault, call your
does not fill)
local Tricity Bendix Service Centre.
nThe selector dial is not correctly positioned
Please make sure you give the model and serial number
of the appliance.
The machine does not fillRating plateThis information can be
Mod. Prod. No. .....................Ser. No. .........
nThe water tap is not turned onfound on the rating plate
(see picture) or on the
nThe water supply has been disconnected
guarantee card.
nThe inlet hose is kinked
nThe water pressure is too low
nThe water inlet filter is clogged
Mod. ..........
nThe door is not closed properlyProd. No. ...........
Ser. No. .........
P0042
The machine empties as it fillsOriginal spare parts can be purchased from Tricity
Bendix Service Centres.
nThe end of the drain hose is too low
In-guarantee customers should ensure that the
nThe end of the drain hose is submerged in water
above checks have been made as the engineer will
nDrain pipe has no vent-holemake a charge if the fault is not a mechanical or
electrical breakdown.
The machine does not drain or spinPlease note that proof of purchase is required for
any in-guarantee service calls.
nYou have selected a gentle wash cycle with the
Rinse Hold option
nThe drain filter is clogged
nThe drain hose is kinked
nThe drainage system pipes are blocked
nThe drain hose extension is incorrect
The machine leaks or overflows
nToo much detergent
nUnsuitable detergent
nThe inlet hose is loose
nThe detergent dispenser drawer or recess is clogged
nThe end of the drain hose is not securely positioned
nThe drainage system pipes are blocked
The machine vibrates or is noisy
nThe internal packing has not been removed
nThe machine is not level
nThe machine is in contact with the wall or furniture
nThe washing load is badly distributed
nThe machine is overloaded
The door does not open
nThe safety device has locked it
nWater in the tub: the door cannot be opened if water
is present in the tub
19 |
ACEC
